Online Reference Guide

Index	Search	Glossary

Contents	Help

Options

Loading Paper into Your Automatic Document Feeder

Loading documents manually

Your Automatic Document Feeder can automatically load up to 30 sheets of the following paper sizes (based on a paper weight of 17 lbs and a stack thickness of 6.0 mm or less):

Checks	85 x 127 mm (3.3 x 5 inches)
B5	182 x 257 mm (7.17 x 10.1 inches)
A4	210 x 297 mm (8.27 x 11.69 inches)
Letter	215.9 x 279.4 mm (8.5 x 11 inches)
Legal	215.9 x 355.6 mm (8.5 x 14 inches)

Follow the steps below to load paper into the Automatic Document Feeder.

Note:

Make sure no documents or dust is on the document table when using the Automatic Document Feeder. Dust on the document table near the carriage home position may result in vertical lines on the scanned images.

Opening the Automatic Document Feeder or its cover while it is operating results in an option error, and paper feeding stops.

Pull out the paper support.

Slide the right edge guide all the way to the right.

Insert the paper stack into the Automatic Document Feeder until it meets resistance. Make sure that the side you want to scan is facing up. Then move the right edge guide so it is flush with the right edge of your paper.

Documents are output into the lower tray after scanning is finished.

Note:

In the following situations, see the respective sections for problem-solving information:

When paper is jammed, see Fixing Paper Jams in the Automatic Document Feeder.

When a scanned image has unwanted lines, see A line of dots always appears in the scanned image..

Loading documents manually

Follow the steps below to load documents manually when the Automatic Document Feeder is installed.

Lift the Automatic Document Feeder.

Place the document on the document table and then place the ADF Document Mat on the top.

Note:

Make sure you always place the ADF Document Mat on the top before you scan an image in the Full Auto mode.

Lower the Automatic Document Feeder and scan the document.

Note:

Always close the Automatic Document Feeder and its cover before scanning. If you are scanning thick material or documents of more than 2 cm in height, you can leave the Automatic Document Feeder at the upright position.

Be sure to select Flatbed in the Document Source settings in the Manual mode.

[Top]