Administrator's Guide

						Index				Search

						Contents				Help

Settings by System / Settings for Macintosh

Configuring for AppleTalk Using EpsonNet MacAssist

Use EpsonNet MacAssist to configure the Internal Print Server as described below.

Turn on the printer.

Double-click the EpsonNet MacAssist icon.

Highlight the printer you want to configure from the list and click Configuration.

Note:

If you have connected more than one printer with the same type of print server to the network, you can distinguish between the printers by the MAC address on the status sheet.

You can search printers in other zones just like a computer by changing the Zone setting in the Option dialog box. See EpsonNet MacAssist dialog box for more information.

The IP Address Configuration and AppleTalk Configuration dialog box appears.

Note:

See Setting the IP Address Using EpsonNet WinAssist/MacAssist for more information about setting the IP address.

Set the following options in the AppleTalk Configuration box.

Printer Name:
Type the printer name (up to 32 characters). The following characters cannot be used; @ : * = ~

Entity Type:
Displays the printer's entity type.

Zone Name:
Select the network zone in which you want the printer to appear.

Network Number Set:
Select either Auto or Manual. Usually Auto is preferred.

Network Number for Manual Mode:
Enter a value between 0 and 65534 when Manual is selected for the Network Number Set.

After making settings, click Send. The Password dialog box appears.

Type your password (up to 20 characters) and click OK to save settings. If you need to set a password, see About passwords.

After updating is complete, refresh the configuration. To do this, quit EpsonNet MacAssist once, then start EpsonNet MacAssist again.

Caution:

Since it takes 2 or 3 minutes to send new settings to the Internal Print Server, you must wait to turn off your printer after the on-screen message appears.

[Top]