Reference Guide

Index	Search	Glossary

Contents	Help

How to / Replacing Consumable Products

Photoconductor Unit

Handling precautions
Replacing the photoconductor unit

Prepare a new photoconductor unit for replacement when you see a message informing you to do so. The photoconductor unit has a slot that accommodates the waste toner collector.

When you purchase a photoconductor unit, it always comes with a waste toner collector because it usually needs replacement at the same time as the photoconductor unit. However, the waste toner collector is also sold individually as you may need to replace it separately depending on use.

Handling precautions

Always pay attention to the following handling precautions before replacing the photoconductor unit:

When replacing the photoconductor unit, avoid exposing it to room light any longer than necessary.

Be sure not to scratch the surface of the drum. Also, avoid touching the drum, since oil from your skin may permanently damage its surface and affect print quality.

To get the best print quality, do not store the photoconductor unit in an area subject to direct sunlight, dust, salty air, or corrosive gases (such as ammonia). Avoid locations subject to extreme or rapid changes in temperature or humidity.

Warning:

Do not dispose of the used photoconductor unit in fire, as it may explode and cause injury. Dispose of it according to local regulations.

Keep the photoconductor unit out of the reach of children.