Reference Guide

Index Search Glossary Contents Help

How to / Replacing Consumable Products

Waste Toner Collector

Handling precautions
Replacing the waste toner collector

Prepare a new waste toner collector for replacement when you get a message informing you to do so. The waste toner collector is sold as part of the photoconductor unit because it usually needs replacement at the same time as the photoconductor unit. However, the waste toner collector is also sold individually as sometimes you may need to replace the waste toner collector separately depending on use.

Handling precautions

Always pay attention to the following handling precautions before replacing the waste toner collector.

• Do not reuse toner found in the waste toner collector.

Warning:

Do not burn used waste toner collectors, because they may explode and cause injury. Dispose of them according to local regulations.

Keep the waste toner collector out of the reach of children.

[Top]

Replacing the waste toner collector

Follow these steps to replace the waste toner collector.

Turn off the printer.

Open the front cover.

Hold the handle of the waste toner collector and push the tab down to release the lock.

Pull out the waste toner collector.

Take the new waste toner collector out of its package.

Insert the new waste toner collector firmly into the slot until the tab clicks into place.

Close the front cover.

[Top]

Previous

Next