|
|
|
|||||||||||||||||||||||||||||||||
Problem Solver
Some or all of the printout is garbled
| Cause | What to do |
| The interface cable may not be plugged in securely. | Make sure that both ends of the interface cable are plugged in securely. |
| You may not be using the correct interface cable. | If you are using the parallel interface, make sure that the cable is a double-shielded, twisted-pair interface cable no more than six feet in length. If you are using the USB interface, use a Revision 1.1 compliant cable. A USB 2.0 certified cable is recommended. |
| Note: If a status sheet does not print correctly, your printer may be damaged. Contact your dealer or a qualified service representative. | |
| Cause | What to do |
| The page length and margins are set incorrectly in your application. |
Make sure that you are using the correct page length and margin settings in your application. |
| Cause | What to do |
|
You may need more memory. |
Graphics require large amounts of memory. Install an appropriate memory module. See Installing a memory module. |
| Cause | What to do |
| Duplex printing on damp coated paper may produce a rough printed surface. | Use coated paper that is newly unwrapped. Always store coated paper in a dry environment. |
 Previous |
 Next |
| Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |
