Reference Guide

Index
Search
Glossary
Contents
Help
Safety

Problem Solver

Printout Problems

The font cannot be printed
Printout is garbled
Misalignment of colors
The printout's orientation on the page is not correct
Graphics do not print correctly

The font cannot be printed

Cause What to do
You may use the printer fonts substituted for specified TrueType fonts. In the printer driver, choose the Print TrueType fonts as bitmap button in the Extended Settings dialog box.

The selected font is not supported by your printer.

Make sure that you have installed the correct font. See Available Fonts for more information.


[Top]

Printout is garbled

Cause What to do
The interface cable may not be plugged in securely. Make sure that both ends of the interface cable are plugged in securely.
You may not be using the correct interface cable. If you are using the parallel interface, make sure that the cable is a double-shielded, twisted-pair interface cable no more than six feet in length. If you are using the USB interface, use a Revision 2.0 cable.
The emulation setting for the port may not be correct. Specify the emulation mode by using the printer's control panel menus. See Emulation Menu.
Note:
If a status sheet does not print correctly, your printer may be damaged. Contact your dealer or a qualified service representative.


[Top]

Misalignment of colors

Cause What to do
The registration position of each color may have shifted while the printer was being shipped or moved to a new location. Check the color registration and adjust the alignment if necessary. See Checking color registration for instructions.


[Top]

The printout's orientation on the page is not correct

Cause What to do
The page length and margins may be set incorrectly in your application. Make sure that you are using the correct page length and margin settings in your application.
The Paper Size setting may be incorrect. Make sure the correct paper size is set in the Tray Menu on the control panel.


[Top]

Graphics do not print correctly

Cause What to do
The printer emulation setting in your application may be incorrect. Make sure that your application is set for the printer emulation you are using. For example, if you are using the LJ4 emulation mode, make sure that your application is set to use a LaserJet 4 printer.

You may need more memory.

Graphics require large amounts of memory. Install an appropriate memory module. See Memory Module.


[Top]


Previous

Next
Version NPD0167-01, Copyright © 2003, SEIKO EPSON CORPORATION