|
|
|
|||||||||||||||||||||||||||||||||
How to / Installing and Removing Options
Installing
Installing the optional Adobe PostScript 3 ROM Kit module (C83239
) into the ROM slot of your printer provides for optimized printing of complex documents through the PostScript printer language.
Follow the instructions below to install the ROM module:
 | Be sure that the printer is not plugged in. |
 | Press the latch on the left side of the printer, and raise the printer cover. |
 | Face the right side of the printer, and using a crosshead screwdriver, remove the two screws holding the side cover in place. Pull the side cover off toward you. |
 | Identify the ROM slot. It is the black slot on the top. Push the ROM module evenly into the slot until the button comes up. |
 | Set the side cover back into place. |
 | Fasten the side cover with the two screws. |
 | Gently close the printer cover. |
 | Plug in the printer and turn it on. |
To verify that the ROM module is correctly installed, print a status sheet. See "Testing the Printer Connection" in the Setup Guide.
If the ROM module is not listed under the Hardware Configurations section of the status sheet, turn off the printer, unplug it, disconnect all interface cables, and review the steps above to make sure you installed the module correctly. If the ROM module still does not show up in the status sheet, contact your dealer or a qualified service representative for assistance.
If your computer is running Windows 98/95 or Windows NT 4.0, you can also confirm that the ROM module is correctly installed by checking the information displayed in the Optional Settings tab of the printer driver.
If your computer is running Windows 3.1 or Windows NT 3.51, see Settings After Installing and Removing Options for instructions on how to update the information in the printer driver.
Follow the instructions below to remove the ROM module:
|
| Be sure that the printer is not plugged in. |
|
| Press the latch on the left side of the printer, and raise the printer cover. |
|
| Face the right side of the printer, and using a crosshead screwdriver, remove the two screws holding the side cover in place. Pull the side cover off toward you. |
|
| Push down on the button of the ROM slot until the ROM module comes up. |
|
| Lift the ROM module from the slot. |
|
| Carefully store the ROM module until you need to use it again. |
|
| Set the side cover back into place. |
|
| Fasten the side cover with the two screws. |
 | Gently close the printer cover. |
 | Plug in the printer and turn it on. |
If your computer is running Windows 3.1 or Windows NT 3.51, see Settings After Installing and Removing Options for instructions on how to update the information in the printer driver.
 Previous |
 Next |
| Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |
