Reference Guide
|
|
Setup & Maintenance / Installing Options
Face-up Tray
Installing the Face-up tray
Removing the Face-up tray
The face-up tray stacks your printouts with the printed surface facing up. All paper types supported by the printer can be used.
Installing the Face-up tray
Follow the steps below to install the Face-up tray.
|
Warning:
|
|
Be careful when working inside the printer as some components are sharp and may cause injury.
|
|
|
Turn the printer off and unplug the power cord.
|
|
Detach the upper-left part of the printer cover by pushing both sides of the cover upward.
|
|
Attach the discharge unit for the Face-up tray by inserting the two pegs into the holes on the printer.
|
|
Confirm that the two pegs fit the holes on the printer, and insert the discharge unit by pushing it downward until it clicks.
|
|
Secure the discharge unit with the two screws provided.
|
|
Press and hold the latch on cover B to unlock the hooks, then open cover B.
|
|
Plug the connector cable of the Face-up tray to the socket on the printer as shown below.
|
|
Attach the connector's fixture by inserting the two pegs into the holes of the printer until it clicks.
|
|
Close cover B.
|
|
Attach the Face-up tray by inserting the pegs into the holes on the printer one side at a time. Do not force both sides in at once.
|
|
Plug the power cord into the printer, then turn it on.
|
To confirm that the optional Face-up tray is installed correctly, print a Status Sheet. See Printing a Status Sheet.
|
Note for Windows users:
|
|
If you are using Windows, and EPSON Status Monitor 3 is not installed, you have to make settings manually in the printer driver. See Making Optional Settings.
|
|
|
Note for Macintosh users:
|
|
When you have attached or removed printer options, you need to delete the printer using Print Setup Utility (for Mac OS X 10.3), Print Center (for Mac OS X 10.2 or below), or Chooser (for Mac OS 9), and then re-register the printer.
|
|
[Top]
Removing the Face-up tray
Follow the steps below to remove the optional Face-up tray.
|
Turn the printer off and unplug the power cord.
|
|
Perform the installation procedure in reverse.
|
[Top]
Version NPD0750-00, Copyright © 2004, SEIKO EPSON CORPORATION |