|
|
Setup & Maintenance / Replacing Consumable Products
When you see the following messages on the LCD panel or the window of EPSON Status Monitor 3, replace the appropriate consumable products. You can continue to print for a short time after a message appears, but Epson recommends early replacement to maintain print quality and extend the life of your printer.
LCD Panel Message |
Description |
Worn Photoconductor |
The photoconductor unit is near the end of its service life. You need to prepare a new photoconductor unit. |
Waste T BoxNearfull |
The waste toner collector is near full of toner. You need to prepare a new waste toner collector. |
Note: |
|
If a consumable product reaches the end of its service life, the printer stops printing and displays the following messages on the LCD panel or the window of EPSON Status Monitor 3. When this happens, the printer cannot resume printing until you replace the depleted consumable products.
LCD Panel Message |
Description |
Replace Toner uuuu* |
The toner cartridge for the indicated color is empty. |
Replace Photocondctr |
The correct photoconductor unit is not used. Printing has stopped to avoid damage to the engine. |
Replace Waste T Box |
The waste toner collector is full. |
* The letters C, M, Y, or K appear in this position, indicating the color of the toner to be replaced. For example, the message Y Toner Low means that the amount of toner remaining in the yellow toner cartridge is low. |
Note: |
|
Even if Replace Toner uuuu or Replace Photocondctr is displayed on the LCD panel, you can print an additional sheets by pressing the Start/Stop button on the control panel. The message on the LCD panel changes from Replace Toner uuuu or Replace Photocondctr to uuuu Toner Low or Worn Photocondctr.
Note: |
|
|
Previous |
Next |
Version NPD0750-00, Copyright © 2004, SEIKO EPSON CORPORATION |