|
|
Printing with DOS (for Stylus C80 only)
Many of the print settings, such as print direction and loading position, can be changed according to the requirements of the print job. Since all of these settings are enabled each time the printer is turned on, they are considered default settings.
The factory default settings are designed to meet the needs of most users, so you may not need to change them. The table below lists the features you can select in the default-setting mode.
Settings |
Options |
Font |
Courier, Roman, Draft |
Pitch |
10 cpi, 12 cpi, 15 cpi, 17.1 cpi, 20 cpi, Proportional |
Print direction |
Auto, Bi-D, Uni-D |
Loading position |
8.5 mm, 3 mm, etc. |
I/F mode |
Auto, Parallel, USB |
Auto I/F wait time |
10 seconds, 30 seconds |
Parallel I/F transfer rate |
Fast, Normal |
Auto line feed |
Off, On |
Character table |
Italic, PC437, PC437 Greek, PC850, PC852, PC853, PC855, PC857, PC866, PC869, MAZOWIA, Code MJK, ISO 8859-7, ISO Latin 1T, Bulgaria, PC774, Estonia, ISO 8859-2, PC866 LAT, PC866 UKR, PCAPTEC, PC708, PC720, PCAR864, PC860, PC861, PC863, PC865, BRASCII, Abicomp, Roman 8, ISO Latin 1, PC858, ISO 8859-15, PC771 |
Note: |
Most software controls the character table and auto line feed. If your software controls these features, you may never need to set them with the control panel. |
Previous |
Next |
Version 1.10E, Copyright © 2002, SEIKO EPSON CORPORATION |