|
|
|
|||||||||||||||||||||||||||||||||
Printing with DOS (for Stylus C80 only)
To change the printer's default settings, use the control panel buttons. Your selections are indicated by the control panel lights. Follow the steps below.
 | Make sure that the printer is turned off and that A4 or Letter size paper is loaded in the sheet feeder. |
 |
Hold down the  ink button and turn on the printer. Then press the paper button to enter the default-setting mode.
|
The printer loads a sheet of paper and prints a brief summary and instructions. It instructs you to select the language that you want messages printed in (English, French, German, Italian, Spanish, or Portuguese).
 |
Press the ink button until the control panel lights indicate the language of your choice, as shown below.
|
|
Language |
|
|
|
|
English |
|
|
|
|
French |
|
|
|
|
German |
|
|
|
|
Italian |
|
|
|
|
Spanish |
|
|
|
|
Portuguese |
|
|
|
 |
 = On,  = Off
|
 |
Press the  paper button to print the current default settings and the next set of instructions, which will appear in the language that you have selected. The printed instructions include submenu tables that list all of the settings that you can change and describe the appearance of the control panel lights for each selection. Follow the instructions to change the settings through the control panel.
|
 | After making your changes, exit the default-settings mode by turning off the printer. |
|  | Note: |
| | You may exit the default-settings mode at any time by turning off the printer. Any settings that you have selected remain in effect until they are modified. |
If you want to check the current default settings, enter the default-settings mode again and print the current default settings. The current settings are indicated by arrows.
 Previous |
 Next |
| Version 1.10E, Copyright © 2002, SEIKO EPSON CORPORATION |
