EPSON

Cleaning the Printer

Cleaning the exterior of the printer

To keep your printer operating at its best, clean it thoroughly several times a year by using the following instructions.
Never use alcohol or thinner to clean the printer. These chemicals can damage the printer.
Use a soft, dry, clean cloth to clean the LCD screen. Do not use liquid or chemical cleaners on the LCD screen.
Use a soft, dry, clean cloth to clean the glass surface of the document table. If the glass surface is stained with grease or some other hard-to-remove material, use a small amount of glass cleaner and a soft cloth to remove it. Wipe off all remaining liquid.
Do not press the glass surface of the document table with any force.
Be careful not to scratch or damage the glass surface of the document table, and do not use a hard or abrasive brush to clean it. A damaged glass surface can decrease the scan quality.
Note:
Close the paper support and the output tray after you use the printer to protect the printer from dust.

Cleaning the interior of the printer

To keep your printouts at their best, clean the roller inside by using the following procedure.
Warning:
Be careful not touch the parts inside the printer.
Caution:
Do not apply grease to the metal parts under the ink cartridge holder.
Be careful to keep water away from the electronic components.
Do not spray the inside of the printer with lubricants.
Unsuitable oils can damage the mechanism. Contact your dealer or a qualified service person if lubrication is needed.
Load several sheets of A4-size plain paper.
Make a copy without placing a document on the document table.
For Stylus SX200/TX200 Series: Press the color or black  Start button.
For Stylus SX400/TX400 Series: Press the  Copy mode button, then press the  Start button.
Repeat step 2 if needed.