Reference Guide

Index	Search	Glossary

Contents	Help

Scanning / How to Scan

Placing Photos and Documents on the Document Table

Removing the document cover for thick or large document

Before scanning a document, remember to respect the rights of copyright owners. Do not scan published text or images without first checking the copyright status.

Caution:

Do not place heavy objects on the glass of the document table. Also, do not press the glass of the document table with too much force.

Open the document cover and make sure the fluorescent lamp on the carriage turns on.

Place the document on the document table, with the side to be scanned facing down. Make sure that the document is carefully aligned with the alignment mark as shown below.

Note:

An area maximum 2.5 mm from the edges of the document table glass will not be scanned.

1. Maximum unreadable area of 2.5 mm
2. Maximum unreadable area of 2.5 mm

In the Full Auto Mode or when previewing images using the Thumbnail method, if you scan multiple photos, position each photo at least 20 mm apart from its adjacent photos.

When using the Copy Center feature in EPSON Smart Panel, place the document in the lower left corner of the document table.

Close the document cover gently so that the document does not move.

Note:

Always keep the document table clean.

Do not leave photographs on the document table for an extended period of time as they may stick to the glass.

Do not place heavy objects on top of this product.

For a thick or large document, you can remove the document cover to make it easier to align the document. See Removing the document cover for thick or large document.

Removing the document cover for thick or large document

When you scan the thick or large document, you can remove the document cover.

Note:

When you set the document without the document cover, make sure to press the document from above and make it flat.

When you press the document, do not move the document and not to add too much pressure.

Removing and installing the document cover

When removing the document cover, open the cover and then pull it up.

When installing the document cover, install it in the reverse order of removing it.

Caution:

Do not use excessive force on the document cover, and do not twist it diagonally. Doing so may damage the document cover.

Do not open and shut the scanner unit without the document cover. It might cause the injury and the breakdown.

[Top]