 |
 |
|
||
 |
||||
Printing on Multipart Forms
Your printer can also print on multipart forms.
You should not print any closer than 13 mm (0.5 inch) from either side of the multipart forms.
Caution:|
When printing on multipart forms or thicker-than-normal paper, make sure your application software settings keep the printing entirely within the recommended printable area. Printing past the edge of these papers can damage the print head.
|
You can use continuous carbonless multipart forms of up to three parts (one original plus two copies). The following tips will help you get good results:
Use only continuous multipart forms that are joined by spot gluing or side-crimping. Never load continuous multipart forms joined by metal staples, tape, or continuous gluing.
Use only multipart forms that are free of wrinkles and waves.
If you need to adjust the loading position, use your application software or change the loading position as described on Adjusting the top-of-form position.
When you use side-crimped continuous multipart forms, the copies may not align with the original.