|
|
Control Panel
Buttons and Lights
1 |
Font button Selects the font. Font lights Indicate which font is selected. |
2 |
Pitch button Selects the font size. Pitch lights Indicate what font size is selected. |
3 |
Pause button Stops printing temporarily, and resumes printing when pressed again. Pause light On when the printer is paused. Flashes when the printer is in the micro adjust mode. |
4 |
Paper Out light On when no paper is loaded in the selected paper source or paper is not loaded correctly. Flashes when paper has not been fully ejected or a paper jam has occurred. |
5 |
Tear Off/Bin button Advances continuous paper to the tear-off position. Feeds continuous paper backward from the tear-off position to the top-of-form position. Selects a cut-sheet feeder bin when the cut-sheet feeder is installed. Enters the card mode to print on postcards and envelopes. See Loading Special Paper. Tear Off/Bin lights
|
6 |
LF/FF button Feeds paper line by line. Ejects a single sheet or advances continuous paper to the next top-of-form position when held down. |
7 |
Micro Adjust
When holding down the Pause button for three seconds, the printer enters the micro adjust mode. Using the micro adjust feature, you can press the |
8 |
Load/Eject button Loads a single sheet of paper. Ejects a single sheet of paper if a sheet is loaded. Loads continuous paper from the standby position. Feeds continuous paper backward to the standby position. |
9 |
Operate button Turns the printer on and off. The printer is off when the top of this button is even with the button protectors. |
|
Next |
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |