Reference Guide

Index
Search
Glossary
Contents
Help

Options and Consumables

Interface Card

Installing an interface card

You can use optional interface cards to supplement your printer's built-in parallel interface. The EPSON interface cards below are compatible with your printer. (Not all interfaces are available worldwide.)

Model number

Card type

C82305 / C82306

Serial interface

C82307 / C82308

32 KB intelligent serial interface

C82312

LocalTalk interface

C82313

32 KB IEEE-488 interface

C82314

Coax interface

C82315

Twinax interface

C82345

IEEE-1284 parallel interface

C82362

EpsonNet 10 Base 2/T Int. Print Server

C82363*/C82364

EpsonNet 10/100 Base TX Int. Print Server

C82384

EpsonNet 10/100 Base TX Int. Print Server

C82391

EpsonNet 10/100 Base Tx Int.
Print Server 2

The asterisk () is a substitute for the last digit, which varies by country.
*  When you use Ethernet interface card C82363, you need to attach the optional interface adapter (C82525) to the interface card.

If you are not sure whether you need an optional interface or would like to know more about interfaces, contact your dealer.

Installing an interface card

Follow these steps to install an optional interface card:

Make sure the printer is turned off. Unplug the printer's power cord and disconnect the interface cable.

Remove the screws securing the shield plate to the back of the printer and remove the plate.

Slide the interface card along the slots on both sides of the interface compartment. Firmly push in the card to make sure the connector at the back of the card is fully inserted into the printer's internal socket. Then replace the screws and tighten them.

Note:
Store the shield plate in a safe place; you will need to reattach it if you remove the interface card later.

To remove the interface card, reverse the steps above.


[Top]


Previous

Next
Version BPS0030-00, Copyright © 2007, SEIKO EPSON CORPORATION