|
1
|
Font button
Selects one of the fonts. To select a font, see Selecting a Font and Pitch.
Font lights
Indicate which font is selected.
|
|
2
|
Reset
When you press both the Font and Pitch buttons simultaneously, the printer clears buffer and returns to its default settings.
|
|
3
|
Pitch button
Selects one of the pitch settings. To select a pitch, see Selecting a Font and Pitch.
Pitch lights
Indicate which pitch is selected.
|
|
4
|
Tear Off/Bin button
-
Feeds continuous paper forward to the tear-off position.
-
Feeds continuous paper backward from the tear-off position to the top-of-form position.
-
Selects a cut-sheet feeder bin when the cut-sheet feeder is installed.
Tear Off/Bin light
-
Flashes when continuous paper is in the tear-off position.
-
On when bin 1 of the optional cut-sheet feeder is selected.
-
Off when bin 2 of the optional cut-sheet feeder is selected.
|
|
5
|
LF/FF button
-
Feeds paper line by line when pressing shortly.
-
Ejects a single sheet or advances continuous paper to the next top-of-form position when held down.
|
|
6
|
Micro adjust
When you hold down the Pause button for three seconds, the printer enters the micro adjust mode. In this mode, you can press the LF/FF  and Load/Eject  buttons to adjust the top of form or tear off position. See Using the Micro Adjust Function.
|
|
7
|
Load/Eject button
-
Loads a single sheet of paper.
-
Ejects a single sheet of paper if a sheet is loaded.
-
Loads continuous paper from the standby position.
-
Feeds continuous paper backward to the standby position if a sheet is loaded.
|
|
8
|
Pause light
-
On when the printer is paused.
-
Flashes when the printer is in the Micro Adjust mode.
|
|
9
|
Pause button
-
Stops printing temporarily, and resumes printing when pressed again.
-
When held down for three seconds, enters the Micro Adjust mode. When pressed again, exits the Micro Adjust mode.
|
|
10
|
Lock
When the lock-out mode is on, the Paper Out and Pause lights flash if a locked button is pressed.
|
|
11
|
Paper Out light
-
On when no paper is loaded in the selected paper source or paper is not loaded correctly.
-
Flashes when paper has not been fully ejected or a paper jam has occurred.
|
