Control Panel

Selecting a Font and Pitch

You can select one of the printer's five fonts and pitch by using the buttons on the printer's control panel, as described below.

Note:

Settings you make in application programs usually override settings you make from the printer's control panel. For best results, use your application to select a font and make other settings.

The available pitch depends on the font you select. See the table below for more information.

Font	Pitch
USD	10, 12
HSD	10, 12, 15, 17, 20
Draft	10, 12, 15, 17, 20, PS
Roman	10, 12, 15, 17, 20, PS
Sans Serif	10, 12, 15, 17, 20, PS

Make sure that the printer is not printing. If it is, press the Pause button to stop printing.

Press the Font button until the three Font lights indicate the desired font as shown below.

				USD
				HSD
				Draft
				Roman
				Sans Serif

=on,

=off

Press the Pitch button until the Three Pitch lights indicate the desired pitch as shown below.

				10 cpi
				12 cpi
				15 cpi
				17 cpi
				20 cpi
				PS

=on,

=off

Make sure that the desired font and pitch are selected.

[Top]