Reference Guide

Index	Search	Glossary

Contents	Help

Options and Consumables

Interface Card

Installing an interface card

You can use optional interface cards to supplement your printer's built-in parallel interface. The EPSON interface cards below are compatible with your printer. (Not all interfaces are available worldwide.)

Model number	Card type
C82305 / C82306	Serial interface
C82307 / C82308	32 KB intelligent serial interface
C82345	IEEE-1284 parallel interface
C82391	EpsonNet 10/100 Base Tx Int. Print Server 2

The asterisk (

) is a substitute for the last digit, which varies by country.

If you are not sure whether you need an optional interface or would like to know more about interfaces, contact your dealer.

Installing an interface card

Follow these steps to install an optional interface card:

Make sure the printer is turned off. Unplug the printer's power cord and disconnect the interface cable.

Remove the screws securing the shield plate to the back of the printer and remove the plate.

Slide the interface card along the slots on both sides of the interface compartment. Firmly push in the card to make sure the connector at the back of the card is fully inserted into the printer's internal socket. Then replace the screws and tighten them.

Note:

Store the shield plate in a safe place; you will need to reattach it if you remove the interface card later.

To remove the interface card, reverse the steps above.

[Top]