|
|
Options and Consumables
Installing an interface card
You can use optional interface cards to supplement your printer's built-in parallel and USB interfaces. The EPSON interface cards listed below are compatible with your printer. (Not all interfaces are available worldwide.)
Model number |
Card type |
C82307/C82308 |
32KB intelligent serial interface |
C82305/C82306 |
Serial interface |
C82312 |
LocalTalk interface |
C82313 |
32KB IEEE-488 interface |
C82314 |
Coax interface |
C82315 |
Twinax interface |
C82345 |
IEEE-1284 parallel interface |
C82362 |
EpsonNet 10 Base 2/T Int. Print Server |
C82363*/C82364 |
EpsonNet 10/100 Base TX Int. Print Server |
C82384 |
EpsonNet 10/100 Base TX Int. Print Server |
C82391 |
EpsonNet 10/100 Base TX Int. Print Server 2 |
The asterisk () is a substitute for the last digit, which varies by country. |
* When you use Ethernet interface card C82363, you need to attach the optional interface adapter (C82525) to the interface card. |
If you are not sure whether you need an optional interface or would like to know more about interfaces, contact your dealer.
Follow these steps to install an optional interface card.
Make sure the printer is turned off. Unplug the printer's power cord and disconnect the interface cable. |
Remove the screws securing the shield plate on the back of the printer and remove the plate. |
Slide the interface card into the slot of the interface compartment. Firmly push in the card to make sure the connector at the back of the card is fully inserted into the printer's internal socket. |
Then reinsert the screws and tighten them.
Note: |
Store the shield plate in a safe place; you will need to reattach it when you remove the interface card. |
To remove the interface card, reverse the steps described above.
Previous |
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |