Control Panel

Selecting a Font and Pitch

You can select one each of the printer's fonts and pitches by using the buttons on the printer's control panel, as described below.

Note:

Settings you make in application programs usually override settings you make from the printer's control panel. For best results, use your application to select a font and make other settings.

The available pitch depends on the font you select. See the table below for more information.

Font	Pitch
HSD	10, 12, 15, 17, 20
Draft	10, 12, 15, 17, 20, PS
Roman	10, 12, 15, 17, 20, PS
Sans Serif	10, 12, 15, 17, 20, PS

Make sure that the printer is not printing.

Press the Font button. The first available font is displayed on the LCD. Press the Font button until the font that you want to use is displayed. The LCD goes back to the original state in a few seconds and the font you selected is set.

Press the Pitch button. The first available font is displayed on the LCD. Press the Pitch button until the pitch that you want to use is displayed. The LCD goes back to the original state in a few seconds and the pitch you selected is set.

[Top]