 |
 |
|
||
 |
||||
Loading Documents in the Automatic Document Feeder (ADF)
You can load your original documents in the ADF to scan multiple pages quickly.
Document specifications
Only load documents that meet the following specifications into the product.
|
Paper size
|
Measurements
|
|
A4
|
210 x 297 mm (8.3 x 11.7 inches)
|
|
Letter
|
215.9 x 279.4 mm (8.5 x 11 inches)
|
|
Legal
|
215.9 x 355.6 mm (8.5 x 14 inches)
|
|
B5
|
182 x 257 mm (7.2 x 10.1 inches)
|
|
A5
|
148.5 x 210 mm (5.8 x 8.3 inches)
|
|
B6
|
128 x 182 mm (5.0 x 7.2 inches)
|
|
A6 (Portrait)
|
105 x 148.5 mm (4.1 x 5.8 inches)
|
|
Size
|
Width: 100 to 215.9 mm (3.9 to 8.5 inches)
Length: 148 to 1,016 mm (5.8 to 40 inches)
|
|
Weight
|
Thickness (All sizes): 50g/m2 to 128g/m2
Less than A6: 60g/m2 to 190g/m2
|
|
Paper type
|
Standard paper, High-quality paper, Recycled paper
|
Document with the following conditions cannot be loaded.
The ink is wet.
The document is ripped, wrinkled, or curled.
The document has staples, paper clips, or other objects attached to it; these may damage the feeder mechanism.
The document has folds or multiple pages are stuck together.
The document has cut-out areas.
The document is a multi-part form or bound.
The document has rear carbon coating.
The document is not paper. For example, if you have loaded a transparent file holder.
The document is transparent.
The document has been created using glossy paper.
Loading documents in the ADF
Important:|
Do not feed photographs or valuable original artwork into the ADF. Misfeeding may wrinkle or damage the original. Scan these documents on the document glass instead.
Remove any documents from the document glass. Make sure there is no dust on the glass before loading documents in the ADF.
 |
 |
Slide the edge guides on the ADF input tray all the way outward.
|
 |
Place the first page of your document in the ADF input tray with the printed side facing up and the top edge facing into the feeder. Slide the paper into the feeder until it meets resistance. Then slide the edge guides over to the edge of the paper.
|
Important:|
Do not load paper above the line just under the
 arrow mark on the edge guides.When loading a stack of paper, fan the paper to remove any paper powder, tap the edges of the paper on a flat surface to align the sheets, and then load it correctly.
Do not load additional documents while the current document is being scanned.
|