Reference Guide
|
|
Setup & Maintenance / Setting Up Your Printer on a Network
Using AppleTalk Under Windows 2000 or Windows NT 4.0
Use the following settings if your machine is running Windows NT 4.0 or Windows 2000, and the printer is connected through an optional network card using the AppleTalk protocol:
-
Use SelecType to set the Emulation Mode-AUX item to PS3. Using the default Auto setting will cause an extra, unneeded page to be printed.
-
On the Device Settings sheet of the printer's Properties dialog box, make sure that SEND CTRL-D Before Each Job and SEND CTRL-D After Each Job are set to No.
-
TBCP (Tagged binary communications protocol) cannot be used as the Output Protocol setting.
[Top]
Version NPD0274-00, Copyright © 2003, SEIKO EPSON CORPORATION |