|
|
|
|||||||||||||||||||||||||||||||||
Product Information / Command Summary
The information in this section is relevant to you if you do advanced programming related to printers.
Your printer has the ability to emulate the following printers depending on the chosen printer emulation mode:
|
LJ-4 |
Hewlett-Packard LaserJet 4000 (PCL 5e) |
|
ESC/P2 |
EPSON LQ-570/1070, LQ-2170 (24-pin) |
|
FX |
EPSON FX-870/1170, FX-880, or LX-100 (9-pin) |
|
GL/2 |
Hewlett-Packard GL/2 graphics language |
|
I239X |
IBM239X plus (24-pin) |
|
PCL6 |
Hewlett-Packard LaserJet 4000 (PCL 6) |
In addition, the following printer control languages are supported:
|
PJL |
Printer Job Language |
|
EJL |
EPSON Job Control Language |
This appendix lists the printer commands for these modes. Most of the commands closely emulate the original printer or the control language; however, some have operational differences because the printers use different technologies.
For more information on selecting emulation modes, see Choosing Printer Emulation. For information on character sets supported in each emulation mode, see the sets of symbols included in the appendix.
 Previous |
 Next |
| Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |
