Reference Guide

Index	Search	Glossary

Contents	Help

Setup & Maintenance / Replacing Consumable Products

Waste Toner Collector

Handling precautions
Replacing the waste toner collector

Handling precautions

Always observe the following handling precautions when replacing the consumable products.

Do not reuse toner found in the waste toner collector.

Warning:

Do not dispose of the used consumable products in fire, as it may explode and cause injury. Dispose of it according to local regulations.

Keep the consumable products out of the reach of children.

[Top]

Replacing the waste toner collector

Follow the steps below to replace the waste toner collector.

Open cover A.

Hold the waste toner collector and draw it out as shown below. When drawing out the waste toner collector, firmly pull it since it has a drag resistance. Take care not to pull it too strongly as it could cause you to fall down.

Note:

When placing the waste toner collector that is removed, stand it on a flat surface as shown below to prevent the toner content from spilling out.

Install a new waste toner collector to the printer as shown below.

Note:

If the waste toner collector is not installed correctly, cover A may not be closed or an error massage will be displayed on the LCD panel. Make sure the waste toner collector is correctly installed in the frame of the printer.

Close cover A.

Warning:

Take care not to get your finger caught in the metal part inside cover A when closing it.

[Top]