Administrator's Guide

						Index				Search

						Contents				Help

Easy Setup for Windows Me/98/95

Connecting Your Printer to the Network

Follow the instructions below to connect the Internal Print Server to the network.

Make sure that your printer is turned off.

Connect one end of the network cable to the RJ-45 connector on the Internal Print Server, and the other end to the network.

Caution:

You must use a Category-5 shielded twisted-pair cable to connect the Internal Print Server to prevent malfunctions.

Note:

The Internal Print Server is set to the default IP address "192.168.192.168". This private IP address may conflict with any other device on your network. Therefore, before connecting the Internal Print Server to the network, make sure this IP address does not already exist on the network. If it does, turn off the device that is using this IP address.

Do not connect or disconnect the network cable when the printer is on.

Be sure to use a hub to connect the Internal Print Server to the network.

Turn on your printer. After the status lights go off, print a network status sheet.

Caution:

After turning off the printer, wait until the status lights go out before turning it back on; otherwise the Internal Print Server may not work correctly.

[Top]