Finding a place for the printer
For long distances
For short distances

When relocating the printer, always choose a location that has adequate space for easy operation and maintenance. Use the following illustration as a guide for the amount of space required around the printer to ensure smooth operation. Dimensions shown in the illustrations below are in centimeters.

To install and use any of the following options, you will need the indicated amount of additional space.

The 550-sheet paper cassette unit adds 127 mm (5.0 in.) to the bottom of the printer.

The 1100-sheet paper cassette unit adds 339 mm (13.3 in.) to the bottom of the printer.

In addition to space considerations, always heed the following precautions when finding a place to locate the printer:

• Place the printer where you can easily unplug the power cord.

• Keep the entire computer and printer system away from potential sources of interference, such as loudspeakers or the base units of cordless telephones.

• Avoid using an electrical outlet that is controlled by wall switches or automatic timers. Accidental disruption of power can erase valuable information in your computer’s and printer’s memory.

Caution:

Leave adequate room around the printer to allow for sufficient ventilation. Avoid locations that are subject to direct sunlight, excessive heat, moisture, or dust. Avoid using outlets that other appliances are plugged into. Use a grounded outlet that matches the printer’s power plug. Do not use an adapter plug. Only use an outlet that meets the power requirements for this printer.

Top

If you need to transport your printer for long distances, carefully repack it using the original box and packing materials.

Follow the steps below to repack your printer.

Turn off the printer and remove the following items:

Power cord Interface cables Loaded paper Photoconductor unit Installed options

Attach the protective materials onto the printer, then repack the printer in its original box.

If you transported your printer for a long distance, you need to check the color registration for possible misalignment. For instructions, see Checking Color Registration.

Top

Always pay attention to the following handling precautions when you need to move the printer for short distances.

If you are moving the printer on its own, two people should lift and carry the printer.

Follow the steps below to move the printer for short distances.

Turn off the printer and remove the following items:

Power cord Interface cables Loaded Paper Photoconductor unit Installed options

Note:

If the 1100-sheet paper cassette unit is installed, unlock the four feet at the bottom of the unit, then roll the printer to the new location. Make sure to lock the feet after relocating the printer.

Be sure to lift the printer by the correct positions as shown below.

Caution:

When moving the printer, always keep it horizontal.

Top