Administrator's Guide
|
|
Easy Setup for Windows Me/98/95
Easy Setup Procedures
This chapter describes how Windows Me/98/95 users can easily set up the printer on the network. TCP/IP printing is recommended here.
To set up the printer on the network, install the necessary protocols and the printer driver, using the following general procedure.
|
Set up your printer. See the Reference Guide for details.
|
|
Install the TCP/IP protocol on the computer used for configuring the Internal Print Server. Also, set the IP address and the subnet mask. If there is a router on the network, set the gateway address as well.
|
|
Use an Ethernet cable to connect your printer to the network.
|
|
Use EpsonNet WinAssist EasySetup to set the IP address of the Internal Print Server.
|
|
For client: Install the TCP/IP protocol on the client computer and set the IP address and the subnet mask. If there is a router on the network, set the gateway address as well. Also, install the printer driver and the EpsonNet Direct Print utility that enables TCP/IP printing.
|
[Top]
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |