|
|
|
|||||||||||||||||||||||||||||||||
Problem Solver
The Ready light does not turn on
| Cause | What to do |
| The power cord may not be properly plugged into the electrical outlet. | Turn off the printer and check the power cord connections between the printer and the electrical outlet. Then turn the printer back on. |
|
The electrical outlet may be controlled by an outside switch or an automatic timer. |
Make sure that the switch is turned on or plug another electrical device into the outlet to check whether the outlet is operating properly. |
| Cause | What to do |
|
The printer is offline. |
Press the |
| Cause | What to do |
| Your computer may not be properly connected to the printer. | Perform the procedure described in "Connecting the Printer to a Computer" in the Setup Guide. |
| The interface cable may not be plugged in securely. | Check both ends of the interface cable between the printer and the computer. |
| You may not be using the correct interface cable. | If you are using the USB interface, use a Revision 2.0 cable. |
| Some error may have occurred. | Check the LCD panel to see if an error message appears. |
| Your application software is not properly set up for your printer. | Make sure that the printer is selected in your application software. |
|
Your computer system's memory is too small to handle the volume of data in your document. |
Try reducing the image resolution of your document in the application software, or install more memory in your computer if you can. |
| Cause | What to do |
|
If you are using Windows, and EPSON Status Monitor 3 is not installed, you have to make settings manually in the printer driver. |
Click the Optional Settings tab, select Update the Printer Option Information Manually, then click Settings. |
 Previous |
 Next |
| Version NPD0667-01, Copyright © 2004, SEIKO EPSON CORPORATION |
Start/Stop button once to switch the printer to ready status.