Reference Guide

Index	Search	Glossary

Contents	Help

How to / Replacing Consumable Products

Waste Toner Collector

Prepare a new waste toner collector for replacement when you get a message informing you to do so. The waste toner collector is sold as part of the Photoconductor Kit because it usually needs replacement at the same time as the photoconductor unit. However, the waste toner collector is also sold individually as sometimes you may need to replace the waste toner collector separately depending on use.

Handling precautions

Always pay attention to the following handling precautions before replacing the waste toner collector:

Do not reuse toner found in the waste toner collector.

Keep the waste toner collector out of the reach of children.

Warning:

Do not dispose of the used waste toner collector in fire, as it may explode and cause injury. Dispose of it according to local regulations.

Replacing the waste toner collector

Follow these steps to replace the waste toner collector:

Open the front cover.

Detach the waste toner collector.

Note:

Be careful not to spill toner when handling the waste toner collector.

Turn and remove the two round caps off the center of the used waste toner collector and attach them to the openings. (The illustrations show the procedure for one cap only.)

Remove the rectangular cap and attach it to the rectangular opening, as shown in the illustration below.

Take out the new waste toner collector.

Attach the new waste toner collector, making sure that it is securely in place.

Close the front cover.

[Top]