Reference Guide

Index	Search	Glossary

Contents	Help

Product Information / Command Summary

Introduction

The information in this section is relevant to you if you do advanced programming related to printers.

Your printer has the ability to emulate the following printers depending on the chosen printer emulation mode:

LJ-4	Hewlett-Packard LaserJet 4000 (PCL 5e)
ESC/P2	EPSON LQ-570/1070, LQ-2170 (24-pin)
FX	EPSON FX-870/1170, FX-880, or LX-100 (9-pin)
GL/2	Hewlett-Packard GL/2 graphics language
I239X	IBM239X plus (24-pin)

In addition, the following printer control languages are supported:

PJL	Printer Job Language
EJL	EPSON Job Control Language

This appendix lists the printer commands for these modes. Most of the commands closely emulate the original printer or the control language; however, some have operational differences because the printers use different technologies.

For more information on selecting emulation modes, see Using SelecType. For information on character sets supported in each emulation mode, see the sets of symbols included under Introduction to Symbol Sets.

[Top]