|
|
Configuring the Internal Print Server / EpsonNet WinAssist Configuration Utility
Time-out option
Search options
EpsonNet WinAssist has the following menus and sub-menus.
Sets the length of time before a time-out occurs (between 2 and 120 seconds). A communication error occurs if this time is exceeded. The default value is 6 seconds. If you set a larger value, it takes more time to search the network printers. Therefore, change this value only if you prefer.
To search for the Internal Print Servers in other segments, set the segment (a network address) using this option. However, what you set here is invalid in EpsonNet WinAssist Easy Setup.
When you want to configure the Internal Print Server outside of the local network, set the specific network address to search for the Internal Print Server in the segment you specified. Restart EpsonNet WinAssist or select Refresh from the View menu for the settings to take effect.
Item |
Explanation |
Search effectiveness of the specific address |
Select this check box to search for an Internal Print Server that is beyond the router. |
Text box |
Enter the network address (valid range 0 to 255) of the Internal Print Server you want to find as described below: Class A: value.255.255.255 Class B: value. value.255.255 Class C: value. value. value.255 |
List box |
Displays network addresses that have been registered. |
Add button |
Registers network addresses (up to 20 addresses). Do not add the network address if it is in the same segment. |
Delete button |
Deletes a network address from the List box. |
OK |
Saves the settings. |
Cancel |
Cancels any changes. |
When you manage the Internal Print Server with IPX (NetWare), and when you want to configure the Internal Print Server outside of the local network, set the network address of the Internal Print Server. Restart EpsonNet WinAssist or select Refresh from the View menu for the settings to take effect.
Note: |
|
|
Item |
Explanation |
Search effectiveness of the specific address |
Display time can be reduced by selecting this check box and choosing the target networks, so that unnecessary or unwanted information is not obtained. |
All Network Address |
Displays all current network addresses. |
Select Search Address |
Displays the network address to be searched. |
Add button |
Select an address in All Network Address, and then click Add to add an address to Select Search Address (up to 256 address). |
Remove button |
Removes an address from the Select Search Address list. |
OK |
Saves the settings. |
Cancel |
Cancels any changes. |
Previous |
Next |
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |