Reference Guide
|
|
Setup & Maintenance / Replacing Consumable Products
Photoconductor Unit
Handling precautions
Replacing the photoconductor unit
Handling precautions
Always observe the following handling precautions when replacing the consumable products:
-
The photoconductor unit weighs 3.0 kg (6.6 lb). Be sure to hold it firmly by the handle when carrying it.
-
When replacing the photoconductor unit, avoid exposing it to light any longer than necessary.
-
Be careful not to scratch the surface of the drum and belt. Also, avoid touching the drum, since oil from your skin may permanently damage its surface and affect print quality.
-
To get the best print quality, do not store the photoconductor unit in an area subject to direct sunlight, dust, salty air, or corrosive gases (such as ammonia). Avoid locations subject to extreme or rapid changes in temperature or humidity.
-
Do not tilt the photoconductor unit.
|
Warning:
|
| -
Do not dispose of the used consumable products in fire, as they may explode and cause injury. Dispose of them according to local regulations.
|
|
| -
Keep consumable products out of the reach of children.
|
|
[Top]
Replacing the photoconductor unit
Follow the steps below to replace the photoconductor unit.
|
Turn the printer on, and open cover B.
|
| |
Note:
|
| |
When installing the optional Duplex Unit, open cover D first, then cover B.
|
|
|
Raise the yellow lever inside cover B.
|
|
Remove the photoconductor unit.
|
|
Take the new photoconductor unit out of its package and remove the protective sheet.
|
| |
Caution:
|
| |
Do not touch the belt on the top of the unit or the blue photo conductor area. Otherwise, the print quality may decrease.
|
|
|
Hold the photoconductor unit by its handle, and insert the unit until it clicks shut with aligning the arrow marks on the printer.
|
| |
Warning:
|
| |
Be careful not to touch the fuser, which is marked CAUTION HIGH TEMPERATURE. If the printer has been in use, the fuser may be very hot.
|
|
| |
Caution:
|
| |
Do not touch the parts inside the printer.
|
|
|
Push the yellow lever down, and then close cover B.
|
| |
Note:
|
| |
When installing the optional Duplex Unit, close cover D.
|
|
[Top]
Version NPD0075-01, Copyright © 2005, SEIKO EPSON CORPORATION |