|
|
Setup & Maintenance / Replacing Consumable Products
When you see the following messages on the LCD panel or the window of EPSON Status Monitor 3, replace the appropriate consumable products. You can continue to print for a short time after a message appears, but Epson recommends early replacement to maintain print quality and extend the life of your printer.
LCD Panel Message |
Description |
Worn Photoconductor |
The photoconductor unit is near the end of its service life. |
Worn Fuser |
The fuser unit has reached the end of its service life. Contact your dealer. |
Worn uuuu Dev Unit |
The developer unit has reached the end of its service life. Contact your dealer. |
Note: |
|
If a consumable product reaches the end of its service life, the printer stops printing and displays the following messages on the LCD panel or the window of EPSON Status Monitor 3. When this happens, the printer cannot resume printing until you replace the depleted consumable products.
LCD Panel Message |
Description |
Replace Toner uuuu* |
The indicated toner cartridge is empty. |
Replace Photocondctr |
Printing has stopped to avoid damage to the engine. |
* The letters C, M, Y, and K appear in this position, indicating the color of the toner to be replaced. For example, the message Y Toner Low means that the amount of toner remaining in the yellow toner cartridge is low. |
Note: |
|
Even if Replace Photocondctr is displayed on the LCD panel, you can continue to print for a short time by pressing the Start/Stop button on the control panel. The message on the LCD panel changes from Replace Photocondctr to Worn Photoconductor.
Note: |
|
|
Previous |
Next |
Version NPD0075-01, Copyright © 2005, SEIKO EPSON CORPORATION |