|
Network Guide
|
|
How To / Installing Components on Your Computer
Macintosh
Mac OS X
Mac OS 9
To assign an IP address, subnet mask, etc. to your Macintosh, follow the steps below.
 |
Note:
|
 | |
To print using the AppleTalk protocol and configure the network interface with EpsonNet Config for Macintosh, select Ethernet or Built-in Ethernet on the AppleTalk Control Panel or the AppleTalk tab. Then configure the network interface with EpsonNet Config for Macintosh.
|
|
Mac OS X
 |
From the Apple menu, select System Preferences.
|
 |
Open the Network control panel. Click the TCP/IP tab.
|
 |
Select Built-in Ethernet from the Show pull down menu.
|
 |
Assign an IP address and other settings if necessary.
|
 |
Click the Apply Now button to save any changes.
|
Go to the section Connecting the Network Interface to the Network.
[Top]
Mac OS 9
|
|
From the Apple menu, select Control Panel, and then TCP/IP.
|
|
|
Set Connect via to Ethernet.
|
|
|
Assign an IP address and other settings if necessary.
|
|
|
Close the dialog box to save any changes.
|
Go to the section Connecting the Network Interface to the Network.
[Top]
| Version NPD0677-00, Copyright © 2005, SEIKO EPSON CORPORATION |
