|
|
Product Information
Parallel interface
Serial interface
Your printer is equipped with an 8-bit parallel interface and a serial interface.
The built-in parallel interface has the following characteristics:
Data format |
8-bit parallel, IEEE-1284 compatibility mode |
Synchronization |
STROBE pulse |
Handshake timing |
BUSY and ACKNLG signals |
Signal level |
TTL compatible |
Connector |
57-30360 Amphenol connector or equivalent |
Transmission mode |
IEEE-1284 Nibble mode |
Adaptable connector |
57-30360 Amphenol connector or equivalent |
Synchronization |
Refer to the IEEE-1284 specification |
Handshaking |
Refer to the IEEE-1284 specification |
Signal level |
IEEE-1284 Level 1 device |
Data transmission timing |
Refer to the IEEE-1284 specification |
Transmission mode |
IEEE-1284 ECP mode |
Adaptable connector |
57-30360 Amphenol connector or equivalent |
Synchronization |
Refer to the IEEE-1284 specification |
Handshaking |
Refer to the IEEE-1284 specification |
Signal level |
IEEE-1284 Level 1 device |
Data transmission timing |
Refer to the IEEE-1284 specification |
The printer's built-in serial interface is based on the RS-423 standard. This interface has the following characteristics:
Standard |
Based on RS-423 |
Synchronization |
Synchronous |
Bit rate |
Approx. 1.8 M bps |
Handshaking |
X-ON/X-OFF and DTR protocol |
Word format |
Data bit: 8 bits |
Connector |
8-pin mini-circular connector |
Recommended cable |
Apple System Peripheral-8 cable |
Previous |
Next |
Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |