 |
 |
|
||
|
||||
 |
||||
Maintenance Mode
Maintenance mode setting procedure
This section describes how to enter Maintenance mode and how to make settings with the buttons on the control panel.
To make the Maintenance mode settings, follow the steps below.
Note:|
Press the Back/Left
 button to return to the previous step. |
 |
Enter Maintenance mode
Confirm the printer is turned off first. While pressing and holding the Cancel/Reset  button, press the Power  button to turn on the printer. |
 |
Select an item
Press the Paper Feed/Down  or Ink Cover Open/Up  button to select a desired item. |
 |
Set the item
Press the Menu/Right  button to enter the selected item. The first parameter is displayed on the LCD panel. |
 |
Select a parameter
Press the Paper Feed/Down or Ink Cover Open/Up button to select a parameter for the item. |
 |
Set the parameter
Press the Enter  button to store the selected parameter. If the parameter is for execution only, press the Enter button to execute the function for the item. |
Note:|
If second parameter is displayed on the LCD panel, repeat the steps 4 and 5 to select and set the second parameter.
|
 |
Exit Maintenance mode
Press the Power button to turn off the printer, and turn it on again. |
Maintenance mode list
|
Item
|
First parameters
|
Second parameters
|
|
ENGLISH, FRENCH, ITALIAN, GERMAN, SPANISH, PORTUGUE, DUTCH
|
-
|
|
|
METRIC, FEET/INCH
|
-
|
|
|
EXECUTE
|
-
|
Details of Maintenance mode items
LANGUAGE
You can select the language to be displayed on the LCD panel.
To select a suitable language, follow the steps below.
|
In Maintenance mode, press the Paper Feed/Down
or Ink Cover Open/Up button to display LANGUAGE, and press the Menu/Right button. |
|
Press the Paper Feed/Down
or Ink Cover Open/Up to select a suitable language. |
|
Press the Enter
button to set the language. Confirm that the READY (or similar word in the language selected) appears on the LCD panel. |
Note:|
It takes a while until READY (or similar word in the language selected) appears.
|
UNIT
You can select a unit of measurement to use to display length. To select a unit, follow the steps below.
|
In Maintenance mode, press the Paper Feed/Down
or Ink Cover Open/Up button to display UNIT, and press the Menu/Right button. |
|
Press the Paper Feed/Down
or Ink Cover Open/Up button to select a suitable unit. |
|
Press the Enter
button to set the unit. |
DEFAULT PANEL
You can set all setting values you made in Menu mode to their factory set value.
|
|||||||||||||
| |||||||||||||
 (NPD4043-00 EN) |
