Home
Overview

This section describes the general procedure on how to set up the network interface for use on a network.

Check the network interface operation.

    Check the functions and operations of the network interface, such as status lights and RJ-45 connector. See Network Interface Operation for details.

Select a printing method.

Install the necessary components on your computer.

    Make sure the necessary components (such as TCP/IP, NetBEUI, etc.) are installed on the computer, and network settings (such as IP address, subnet mask, etc.) of the computer is set. See About Installing Components on Your Computer for details.

Connect the network interface to the network.

Configure the network interface and install the printer driver.

If necessary, configure the network settings of the network interface using EpsonNet Config.