|
|
The Control Panel
How to enter the maintenance mode
Items
Hex dump
Language
MW7
Using the maintenance mode you can perform a hex dump and select the language to be displayed on the LCD.
While pressing and holding the Pause button, press the Power button to turn on the printer.
MAINTENANCE MODE is displayed on the LCD while the printer enters maintenance mode.
Item |
Parameters |
HEX DUMP |
|
LANGUAGE |
ENGLISH*, FRENCH, ITALIAN, GERMAN, SPANISH, PORTUGUE. |
MW7 |
A*, B |
Auto nozzle check |
ON*, OFF |
PARA, I/F |
ECP*, COMPAT |
IEEE1284.4 |
ON*, OFF |
* Factory set value |
Data received from the host can be printed out in hexadecimal numbers.
Load paper into the printer. |
In maintenance mode, press the Item button to display HEX DUMP. |
Press the Enter button. The print data in the print buffer is printed with 16-byte hex. data in the left column, and corresponding ASCII characters in the right column. |
Notes: |
If the last data is less than 16 bytes, it is not printed until you press the Pause button. |
You can select the language to be displayed on the LCD.
In maintenance mode, press the Item button until LANGUAGE = ENGLISH* is displayed. |
If you want to change the language, press the + or - button until a suitable language is displayed. Example: LANGUAGE = FRENCH |
Press the Enter button to set the language. Confirm that the READY message is displayed. |
To exit the maintenance mode, press the Power button to turn off the printer. |
Note: |
To return to maintenance mode while an item is displayed, press the SelecType button. |
MW7 is for test printing and shall only be used by a qualified service representative.
Previous |
Version 1.00E, Copyright © 2001, SEIKO EPSON CORPORATION |