Reference Guide

Index	Search	Glossary

Contents	Help

The Control Panel

Maintenance Mode

How to enter the maintenance mode
Items
Hex dump
Language
MW7

Using the maintenance mode you can perform a hex dump and select the language to be displayed on the LCD.

How to enter the maintenance mode

While pressing and holding the Pause button, press the Power button to turn on the printer.

MAINTENANCE MODE is displayed on the LCD while the printer enters maintenance mode.

[Top]

Items

Item	Parameters
HEX DUMP	PRINT
LANGUAGE	ENGLISH*, FRENCH, ITALIAN, GERMAN, SPANISH, PORTUGUE.
MW7	A*, B
Auto nozzle check	ON*, OFF
PARA, I/F	ECP*, COMPAT
IEEE1284.4	ON*, OFF

* Factory set value

[Top]

Hex dump

Data received from the host can be printed out in hexadecimal numbers.

Load paper into the printer.

In maintenance mode, press the Item button to display HEX DUMP.

Press the Enter button.
The print data in the print buffer is printed with 16-byte hex. data in the left column, and corresponding ASCII characters in the right column.

Notes:

If the last data is less than 16 bytes, it is not printed until you press the Pause button.

[Top]

Language

You can select the language to be displayed on the LCD.

In maintenance mode, press the Item button until
LANGUAGE = ENGLISH* is displayed.

If you want to change the language, press the + or - button until a suitable language is displayed.
Example: LANGUAGE = FRENCH

Press the Enter button to set the language. Confirm that the READY message is displayed.

To exit the maintenance mode, press the Power button to turn off the printer.

Note:

To return to maintenance mode while an item is displayed, press the SelecType button.

[Top]

MW7

MW7 is for test printing and shall only be used by a qualified service representative.

[Top]