|
|
How To / Using Roll Paper
Removing roll paper from the printer using the control panel
Follow the procedure described below to remove the paper from the printer.
Press the roll paper button to feed the paper. A cutting guideline is printed on the roll paper. |
Note: |
|
Cut the paper along the printed line. Never pull the paper as you cut it, otherwise the printout may be damaged. When cutting the paper, do not cross the line towards the printer, as this may cause paper feed problems. |
Note: |
|
Set the adjust lever to the position. |
Turn back the roll paper knob and roll up the roll paper. Gently remove the paper. |
Set the adjust lever to the position. |
After cutting the paper, hold down the roll paper button for about 3 seconds. The paper feeds in reverse to a position where it can be easily removed from the sheet feeder at the back of the printer. The paper light flashes. If it does not feed to this position, repeat this step. |
Turn back the roll paper knob and roll up the roll paper. Gently remove the paper, and then press the roll paper button to clear the paper light. |
Previous |
Next |
Version 1.00E, Copyright © 2002, SEIKO EPSON CORPORATION |