 |
 |
|
||
 |
||||
Problems Specific to the Operating System
Mac OS X
The printer does not appear in Add Printer
Is the printer driver installed?
Install the printer driver. For details about software setup, see Using the Printer from a Second Computer.
Install the printer driver. For details about software setup, see Using the Printer from a Second Computer.
Is the network service at the top of the network list?
If both wired and wireless LAN services are enabled on your computer, it may not be able to find the printer. In this case, follow the instructions below to set the network service you want to use at the top of the list.
Mac OS X 10.3/10.4:
1. Open System Preferences - Network.
2. Select Network Port Configurations from the Show pull-down menu.
3. Drag Use network service to the top of the list.
4. Click Apply to apply the settings and then close the Network window.
Mac OS X 10.5:
1. Open System Preferences - Network.
2. Click the
icon to select Set Service Order.
3. Drag Use network service to the top of the list.
4. Click OK.
5. Click Apply to apply the settings.
If both wired and wireless LAN services are enabled on your computer, it may not be able to find the printer. In this case, follow the instructions below to set the network service you want to use at the top of the list.
Mac OS X 10.3/10.4:
1. Open System Preferences - Network.
2. Select Network Port Configurations from the Show pull-down menu.
3. Drag Use network service to the top of the list.
4. Click Apply to apply the settings and then close the Network window.
Mac OS X 10.5:
1. Open System Preferences - Network.
2. Click the
icon to select Set Service Order.3. Drag Use network service to the top of the list.
4. Click OK.
5. Click Apply to apply the settings.
Are the network settings configured on the computer?
The settings vary depending on the protocol. Try the following:
EPSON TCP/IP: Open System Preferences - Network - TCP/IP (Mac OS X 10.3) or open System Preferences - Network - Advanced - TCP/IP (Mac OS X 10.5), and check whether the addresses are set or if the correct IP address different from the factory setting is set on the printer’s network interface. See Confirming Your Network Settings with a Computer.
The settings vary depending on the protocol. Try the following:
EPSON TCP/IP: Open System Preferences - Network - TCP/IP (Mac OS X 10.3) or open System Preferences - Network - Advanced - TCP/IP (Mac OS X 10.5), and check whether the addresses are set or if the correct IP address different from the factory setting is set on the printer’s network interface. See Confirming Your Network Settings with a Computer.
