 |
 |
|
||
 |
||||
Setting Up the Auto Duplexer
Note:|
Depending on the model, the Auto Duplexer is optional.
The illustrations in this section show the PX810FW/TX810FW Series.
|
Attaching the Auto Duplexer
 |
Turn off the printer.
|
 |
Remove the rear cover by squeezing the hook on the right side.
|
 |
Insert the both sides of the connector of the Auto Duplexer along the slits of the printer.
|
 |
Holding the buttons on the sides, horizontally insert the Auto Duplexer into place.
|
Removing the Auto Duplexer
|
Turn off the printer.
|
Note:|
If you are removing the Auto Duplexer to remove jammed paper, do not turn off the printer.
|
|
Remove the Auto Duplexer by pressing the buttons on the sides.
|
|
Attach the rear cover that you removed when you attached the Auto Duplexer.
|
