 |
Initializing the Network Interface Settings
If you want to restore the network settings to the factory default settings, follow the instructions below.
Using the LCD panel
 |
Enter the Setup mode.
|
 |
Select Restore Default Settings.
|
 |
Select Restore Network Settings or Restore All Settings.
|
 |
Select Yes to restore the factory default settings.
|
Using buttons on the control panel
 |
Make sure printer is turned on.
|
 |
Hold down WiFi for ten seconds.
|
 |
Both WiFi and  are turn off.
|
 Note:
This function does not work during a initial setup.
|
Using EpsonNet Config
 |
Start EpsonNet Config.
|
 |
Select your printer name, then click Configuration.
|
 |
Click Default Settings.
|
 |
When the Transmission is complete screen appears, click OK.
|
|  |