![](files/01.gif) |
Loading Paper
Follow these steps to load paper:
![](files/step_1.gif) |
Open the paper support, then slide out the extension.
|
![](files/step_2.gif) |
Open the front cover.
|
![](files/step_3.gif) |
Slide out the front tray.
|
Make sure the front tray is in the paper position (lower position). If it is not, move the tray lever up and reposition the front tray.
![](files/mark_ca.gif) Caution:
Do not touch the front tray when operating the tray lever.
Do not move the tray lever while the printer is operating.
|
![](files/mark_no.gif) Note:
Before you move the tray lever, make sure no paper or other objects are on the front tray and the front tray is not extended.
|
![](files/step_4.gif) |
Slide the edge guide to the left.
|
![](files/step_5.gif) |
Fan a stack of paper, then tap it on a flat surface to even the edges.
|
![](files/step_6.gif) |
Load the paper with the printable side up against the right side of the sheet feeder, and place it behind the tabs. The printable side is often whiter or brighter than the other side.
|
![](files/step_7.gif) |
Slide the left edge guide to the left edge of the paper, but not too tightly. Make sure it fits under the arrow inside the left edge guide.
|
![](files/mark_no.gif) Note:
Leave enough space in front of the printer for the paper to be fully ejected.
Always load paper into the sheet feeder short edge first, even when you are printing landscape-oriented pictures.
|
| ![](files/01.gif) |