This section provides instructions on how to load paper in the sheet feeder.
Open the paper support, slide out the extensions, and then open the feeder guard.
Lower the output tray and slide out the extension.
Slide the left edge guide so that the distance between the two edge guides is slightly wider than the paper you are going to load.
Load the paper with the printable side up so it is against the right edge guide, and slide it into the sheet feeder.
Slide the left edge guide so that it meets the left edge of the paper.
Note:
Leave enough space in front of the printer for the paper to be fully ejected.
Always load paper into the sheet feeder short edge first, even when you are printing landscape-oriented pictures.
Make sure that the paper stack is flush with or lower than the arrow mark on the edge guide.
Make sure that the paper is loaded under the tabs inside the edge guides.
Ensure that you set the paper thickness lever to the position. If you print on paper other than envelopes when the lever is set to the position, print quality and speed will be compromised.
arrow mark on the edge guide.
position. If you print on paper other than envelopes when the lever is set to the 
position, print quality and speed will be compromised.
