![](IMAGES/R_LOGO.GIF)
Reference Guide
|
|
Printing / Basic Printing Information
Loading Single Sheets of Paper
This section provides instructions on how to load paper in the sheet feeder.
![](IMAGES/R_NOTE.GIF) |
Note:
|
![](IMAGES/R_SPACE.GIF) |
Leave enough space in front of this product for paper to be fully ejected.
|
|
![](IMAGES/R_1.GIF) |
Open the output tray.
|
![](IMAGES/R_2.GIF) |
Move the feeder guard towards you.
|
![](IMAGES/R_3.GIF) |
Fan a stack of paper, and then tap it on a flat surface to even the edges.
|
![](IMAGES/R_4.GIF) |
While holding down its locking tab, slide out the left edge guide.
|
![](IMAGES/R_5.GIF) |
Load the stack of paper with the printable side facing up and resting against the guide of the feeder guard.
|
![](IMAGES/R_6.GIF) |
Stand the stack of paper against the paper support.
|
![](IMAGES/R_SPACE.GIF) | ![](IMAGES/R_NOTE.GIF) |
Note:
|
![](IMAGES/R_SPACE.GIF) | ![](IMAGES/R_SPACE.GIF) | -
Always load paper into the sheet feeder's short edge first.
|
|
![](IMAGES/R_SPACE.GIF) | ![](IMAGES/R_SPACE.GIF) | -
Make sure that the paper stack fits under the arrow mark inside the edge guide.
|
|
![](IMAGES/R_7.GIF) |
Set the feeder guard back.
|
![](IMAGES/R_SPACE.GIF) | ![](IMAGES/R_NOTE.GIF) |
Note:
|
![](IMAGES/R_SPACE.GIF) | ![](IMAGES/R_SPACE.GIF) |
If the paper is curled, flatten it or curl it slightly toward the opposite side before loading. Printing on curled paper may cause ink to smear on your printout.
|
|
![](IMAGES/R_ICTOP.GIF)
[Top]
Version NPD0311-00, Copyright © 2004, SEIKO EPSON CORPORATION |