EPSON

Loading Paper

Follow these steps to load paper:
Open and extend the paper support.
Slide out the output tray and extension.
Flip the feeder guard forward, then pinch and slide the edge guide.
Fan a stack of paper, then tap it on a flat surface to even the edges.
Load the paper with the printable side up against the right side of the sheet feeder, and place it behind the tabs. The printable side is often whiter or brighter than the other side.
Slide the left edge guide to the left edge of the paper, but not too tightly. Make sure it fits under the arrow inside the left edge guide. Then, flip the feeder guard back.
Note:
Leave enough space in front of the printer for the paper to be fully ejected.
Always load paper into the sheet feeder short edge first, even when you are printing landscape-oriented pictures.