Close

Envelopes

Follow the steps below to load envelopes into this product.

Lower the output tray and slide out the extension.

Move the feeder guard towards you.

While holding down its locking tab, slide the left edge guide so that the distance between the two edge guides is slightly wider than the width of your envelopes.

Load envelopes short edge first with the flap side down, as shown in the illustration.

Use the line on the feeder guard as the indicator when loading envelope. The right edge of envelope is aligned with the line on the feeder guard.

Set the feeder guard back.

Note:

The folding quality and thickness of envelopes vary widely. If the total thickness of the stack of envelopes exceeds 10 mm, press each envelope in the stack flat before loading. If print quality declines when a stack of envelopes is loaded, load one envelope at a time.

Do not use envelopes that are curled or folded.

Flatten the envelope flaps before loading.

Avoid using envelopes that are too thin as they may curl during printing.

[Top]

Close