EPSON

Standards and Approvals

WARNING:
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
The connection of a non-shielded printer interface cable to this printer will invalidate the EMC standards of this device.
You are cautioned that changes or modifications not expressly approved by Seiko Epson Corporation could void your authority to operate the equipment.

Safety approvals

120 V model:
Safety standards
UL60950-1
CAN/CSA C22.2 No.60950-1
EMI
FCC part 15 subpart B Class A
ICES-003 Class A
230 V model:
Safety standards
IEC/EN60950-1
EMI
AS/NZS CISPR22 class A

CE marking

230 V model:
Low Voltage Directive 2006/95/EC
EN60950-1
EMC Directive 2004/108/EC
EN55022 class A
EN61000-3-2
EN61000-3-3
EN55024

FCC compliance statement for United States users

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

For Canadian users

This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.